Gehe zu Anwendung: [ 0 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z ]

Gehe zu RPM-Paket: [ 3ABCDEFGHIJKLMNOPQRSTUVWXYZ ]

irda: Necessary Tools for Using the Infrared Port

(auf gut Glück)		(meist engl.)		(falls vorhanden)

Zusammenfassung (meist engl.)

This package contains all necessary scripts and programs for setting up and using the infrared port for printing or communicating. The start and stop scripts are prepared to access the UART emulation ('SIR' mode) with 115 kbit/s data transfer rate. This is supported by most laptops with an infrared interface. After starting the infrared protocol manager 'irmanger' with the command 'rcirda start', you can send data to your printer using the device file /dev/irlpt0. If you like to talk to other computers with infrared interface or to a mobile phone, you can use the serial emulation provided by the device file /dev/ircomm0. Take a look at the README file located in /usr/share/doc/packages/irda/README and the IRDA HOWTO in /usr/share/doc/howto/en/IR-HOWTO.gz. If the infrared port on your laptop is located on an IO or IRQ address other than IO address 0x2f8 (/dev/ttyS1) or interrupt 3, you should use YaST to change the variables IRDA_PORT and IRDA_IRQ in the configuration file /etc/rc.config. Authors: -------- Dag Brattli <dagb@cs.uit.no> Pontus Fuchs <pontus.fuchs@vicecomputer.se> Fons Botman <budely@tref.nl> Andy Choi <kc49@cornell.edu>